Charging the 12V battery in the Terramar PHEV

Tomster

Ist öfter hier
Hello everyone,

I was wondering how I can/may charge the 12V battery in the Terramar PHEV? My dealer showed me charging points in the engine area (the battery is in the boot). Can you just charge the battery like that without risking damage to the electronics? How do I connect it and what should I pay attention to, if anything?

Thanks for any tips /\

Best regards, Tom
 
Als Dir dein Händler die Ladepunkte gezeigt hat, habt Ihr dann darüber nicht gesprochen?
Frag doch Ihn, dann weist es aus erster Hand.
 
Hast Du schon im verbotenen Buch nachgelesen? Auf Seite 394 findet sich die Herstellerempfehlung:

1759926190024.png

HIer ging es auch schon mal um das Thema:
 
The mass tongue on the firewall and the positive tongue in the fuse box have been specifically installed to charge the 12V battery while it is installed, providing easily accessible connection points for jump-starting. The professional service does nothing different than the layperson. Before I replaced the 12V battery in my PHEV on my own, I charged the battery through these connection points very, very often. Ultimately, I replaced it.
 
Last edited:
Vielen Dank an alle für die Tipps und Hinweise.
Noch zwei Fragen:
1. Weiß jemand, ob eine Standard Nass-/Bleibatterie oder eine AGM-Batterie verbaut ist ?
2. Gibt es beim Anklemmen des Ladegerätes etwas zu beachten ? (Zündung aus ?, Verschließen nach dem Anklemmen ?)

Danke im Voraus…
 
An EFB battery must be installed. Generally, when charging, turn off the ignition, first connect the positive, then connect the negative, and only then connect the charger to the power grid, and then turn on the device. You do not need to lock it.

After the charging process is complete, first turn off the charger, then disconnect it from the power grid. Then disconnect the negative, and afterwards disconnect the positive.

The reason for the order of positive/negative or vice versa is as follows: If the charger happens to have power when connecting the terminals and you mistakenly connect the negative first, this will logically transfer to the entire body. If you then connect the positive and accidentally touch the conductive body, you create a short circuit. Therefore, always connect the positive first and then the negative. Even if you touch the body with the positive, there is still no negative from the charger connected. When disconnecting, for the same reason, proceed exactly in reverse: first remove the negative, then the positive.
 
Last edited:

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

cupra.forum · Alle Rechte vorbehalten · Dies ist kein Forum der Seat Cupra S.A.U.
Back
Top