Hello everyone,
I've been driving my new Cupra Leon ST VZ for about a month now and I'm very satisfied. Even before I received the car from my dealer, it was clear to me that I wanted to install a dashcam with front and rear cameras to protect myself from potential "problems" on the road.
Since day one, I've been using the front camera, which I connected to the 12V socket in the centre console. That has worked well so far, and I want to stick with it for now, even though I also bought a hardwire kit.
Today, I wanted to install the rear camera, which is not entirely straightforward due to the cable routing. I did some research beforehand and watched a few videos to avoid mistakes. It was particularly important to me to route the cable invisibly within the vehicle.
Everything actually went well, but when I wanted to reassemble everything, I noticed a mishap: I damaged the attachment of the cable channel on the tailgate. Although I thought I was being careful enough, the little nub that presses the channel watertight against the body partially broke off
Ideally, I would like to replace the entire part, but that's problematic as I could lose the warranty (work on the vehicle's electronics). Alternatively, I thought about gluing the channel to the body, but I'm unsure about that. I hope someone here in the Forum can give me a Tipp on how to repair the damage and restore the watertightness. I'm afraid that the electronics in the rear or the headliner will be damaged by incoming water.
Thank you in advance for your help!
I've been driving my new Cupra Leon ST VZ for about a month now and I'm very satisfied. Even before I received the car from my dealer, it was clear to me that I wanted to install a dashcam with front and rear cameras to protect myself from potential "problems" on the road.
Since day one, I've been using the front camera, which I connected to the 12V socket in the centre console. That has worked well so far, and I want to stick with it for now, even though I also bought a hardwire kit.
Today, I wanted to install the rear camera, which is not entirely straightforward due to the cable routing. I did some research beforehand and watched a few videos to avoid mistakes. It was particularly important to me to route the cable invisibly within the vehicle.
Everything actually went well, but when I wanted to reassemble everything, I noticed a mishap: I damaged the attachment of the cable channel on the tailgate. Although I thought I was being careful enough, the little nub that presses the channel watertight against the body partially broke off
Ideally, I would like to replace the entire part, but that's problematic as I could lose the warranty (work on the vehicle's electronics). Alternatively, I thought about gluing the channel to the body, but I'm unsure about that. I hope someone here in the Forum can give me a Tipp on how to repair the damage and restore the watertightness. I'm afraid that the electronics in the rear or the headliner will be damaged by incoming water.
Thank you in advance for your help!
