Ich habe schon sehr genau hingehört. Radio aus, Klima aus, selbst eine vorbeifahrt habe ich bei mir machen lassen. Nichts. Auch kein knacken in der Lenkung dass einige beim kompletten Einschlag haben.

Eventuell wurde aber auch inzwischen ein Teil ausgetauscht. Hab zwar MJ 25, aber eines der letzten.
 
Hi, für mich ist das Gejaule ein K.O. Kriterium. Ich finde es einfach nur peinlich . Über 60t€ und dann nichts machen wollen, danke Cupra für nix. Bin froh die Kiste nur für 2 Jahre geleast zu haben. Dann geht er wieder zurück und ich bin durch damit. Ein Glück!!! Traurig nur für den neuen Besitzer dann.
 
Sprecht ihr von diesem Geräusch?
Das ist mein Geräusch (bitte Kopfhörer nutzen) Cupra Leon ST 190 PS 2024 - Wummern Orgelton Geräusch 140kmh -> siehe ab Sekunde 8/9, insb. +/- 140kmh, auch wenn man vom Gas geht (bzw. auch keine Veränderung bei manuellem Gangwechsel), was eigentlich gegen Getriebe/Antrieb spricht (aber wer weiß).
-> Zig Reifenwechsel/Umstecken sowie nun Radlager-Wechsel vorne rechts haben bis dato nichts gebracht. Ich versuche jetzt nochmal über die Bremsen bzw. Bremssattel etwas zu erreichen.
Denn: Das ist das vergleichbare Geräusch (mindestens 80% Übereinstimmung): Audi A7 4G Wummern -> siehe ab Sekunde 9 - "Das Problem waren die Führungen in den Bremssätteln. Ein Ausbauen und Reinigen, sowie anschliessendes Fetten, hat Abhilfe geschaffen."
Thread: https://cupra.forum/threads/wuuuh-bzw-orgelton-artige-geräusche-bei-140-km-h.838/#post-12230
 
Hi, I have been driving a VZ extreme 333PS with Akebono brakes since the beginning of 2026.
I have had the same problem from the start. Whether in original condition or with a 30mm lowering and 10mm spacers, it remains. I have now switched back to original... it remains. With summer tires, lowering, and spacers, it suddenly became extreme from about 130 km/h, to the point where it felt like the tires were going to fly off. Only when I braked down to below 100 km/h did it stop again. 120 is possible... from 130 it starts again every now and then. The summer tires were replaced because they were completely worn down in a sawtooth pattern after about 7,500 km. The alignment was always adjusted and measured.
Now back in original condition and with winter tires, it is still there. It simply cannot be that nothing is being done about this by Cupra.
Furthermore, I have had various software problems from the beginning and have already been to the workshop 7 times this year for that reason. Never again a car from this group.
 
Sodala, I have now had my 2nd VZ 333 for 3 weeks and the NOISE is still present, but by far not as loud anymore.
 
Sorry if this has already been mentioned somewhere (certainly), but I have this "whistling" (others might say thumping) at around 80 - end 80 (so OFTEN, because it's country road speed) with my new Formentor VZ333. I'm strongly guessing it's the well-known noise from the Torque Splitter. It's just "state of the art". Don't focus on it, it's been fine since then.
 

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

Back
Top