Self-built accessories

I see it the same way. Where is the Buy It Now button?
 
Yes, I was wondering about that too. Two large, full bottles have quite a leverage effect on the relatively small clamp. On the outside, you could make the wall a bit longer (perhaps in a triangular shape, pointing down like an arrowhead). On the inside, there’s also the possibility that the bottom for the compartment could be attached to the clamp, which would provide a stable support there as well. I wouldn't find a glue variant optimal, as the holder is only intended for temporary use during travel and shouldn't remain attached all the time (at least that would be my preference).
 
In my opinion, the cup holders could be placed directly above the recess, and the indentation could be used entirely as a wedge. I think that with the shifted center of gravity, it would hold better during braking, acceleration, and in curves. I certainly do not need this recessed storage.
 
... I first need to check whether it holds purely through a clamp, possibly supported by double-sided tape
What if you print the entire cutout? Then you could put crumbly snacks in there or something. 😁
 
Instead of just the floor, the complete storage compartment would also be more practical in my opinion, but it would certainly be more complicated to find the optimal fit.
 
I believe that the thing with cups inside looks extremely front-heavy and I would be afraid that it would break. Then you'd have sauce everywhere in the car...
 
You can only test by using closed bottles as test objects; I wouldn't use an open cup in the car anyway.
 
We have never eaten or drunk in the car. One can manage that for a while. Even when the kids were little: That's why you take breaks on long journeys. There is also no onboard toilet in the car.😉
 
The onboard toilet will then be the next project 🤣
 
  • Like
Reactions: ekm
@flash I think you weren't on the current page when you replied; the discussion about the shopping tokens hasn't been relevant for several pages now ;)
 
Hello Milan,
I stumbled upon this great discussion post today by chance.
It's amazing what you've created. The garage door opener for the Leon is particularly well done. I might need something like that in February/March 2027 for our Cupra Raval Endurance. Is the circuit board compatible with all radio-controlled garage doors? The holder for the charging pad in the Leon is also practical. The coins at the very beginning looked top-notch as well. Can I order the parts from you via PM?
I take my virtual hat off to such creativity and commitment.
Regards,
SirOssy
 

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

cupra.forum · Alle Rechte vorbehalten · Dies ist kein Forum der Seat Cupra S.A.U.
Back
Top