Underbody protection & engine/marten protection

Melfinos

Lebt hier ★
Supporter
European-Union
Hello everyone,

maybe someone among you can say something about the topic, has information and experiences.

What does the underbody protection look like for the facelift in relation to the engine? Is there one and is it full-surface?

If it were full-surface, could a marten still get in?

Is there an electric marten protection available in the Cupra accessories as an option to increase protection against marten damage?
 
Last edited:
So with my facelift, it’s as open at the bottom as the Brandenburg Gate! A dog could fit through there. Since I also have it in my other car, I got a marten device from "Mardersicher". It uses ultrasound and flashing light. So far, after 2 marten attacks, it has worked great. There are also electric plates available.


 
Since I once had damage caused by a marten, I have had a marten repellent installed in every car, and since then I have had no problems. However, I would always recommend the version with the electrical contacts; it is the most effective. I would advise against using only ultrasound—if you’re going to do something, it’s better to invest a bit more.
 
I can certainly confirm that. It hardly gets better than with the electric plates. Nevertheless, ultrasound (alternating) and strobe light in combination have solved my problem so far.
 
So, für Interessierte am Ultraschall-/Blitzgerät habe ich mal ein paar Fotos gemacht, wo ich mir einen Halter zurechtgebogen habe und einen Schalter verbaut habe. Das Ganze dauert natürlich noch etwas. Sieht aber ganz ok aus.
 

Attachments

  • PXL_20250121_154431377.jpg
    PXL_20250121_154431377.jpg
    3 MB · Views: 17
  • PXL_20250121_154447690.jpg
    PXL_20250121_154447690.jpg
    2.6 MB · Views: 16
  • PXL_20250121_154538413.jpg
    PXL_20250121_154538413.jpg
    2.4 MB · Views: 16
  • PXL_20250121_154613584.jpg
    PXL_20250121_154613584.jpg
    2.2 MB · Views: 15
  • PXL_20250121_154551744.jpg
    PXL_20250121_154551744.jpg
    2.3 MB · Views: 15
VAG accessories on the topic of marten defense for the Cupra:
Electric plates and ultrasound
Part number: 000 054 650 J
 
Last edited:
In unserer Dienstwagenflotte haben wir das (Stromplatten + Akustik) 260 Netto inkl. Einbau.

20241022_114725.jpg20241022_114715.jpg20241022_114708.jpg
 
zum Marderschutz haben wir übrigens schon einen thread

hier werden ja Geschütze aufgefahren, Herrschaftszeiten.

Im T- ROC- Forum genauso, aber auch die "Marder- Versteher"- Variante: "möchte den Marder nicht töten, sondern vertreiben".
Da ich bisher noch NIE einen Marderbiss hatte, fange ich mal klein an:


Ein "Duftsäckchen" soll auch helfen. Sobald ich den link habe, poste ich ihn hier.
 
Last edited:
hauptsächlich um Unterboden-/Motorschutz bzw. Unterfahrschutz im Bereich des Motors.
verstehe, ist mit #2 aber gleich auf "Marderschutz" umgeschwenkt.

Der ROC hat einen Motorunterbodenschutz, der mir auf der BAB schon einmal einen größeren Schaden "abgefangen" hat. Er ist aber nicht so dicht, dass ein Marder nicht an den Rändern in den Motorraum klettern kann. Seinerzeit hatte ich (im ROC- Forum) gefragt, ob der Unterboden nicht so zu optimieren wäre, dass i.S. Deiner Frage, ein Marder nicht in den Motorraum kommt. Fachkundige meinten, das ginge nicht.

Wenn der FL keinen Unterbodenschutz hat, würde ich (aus o.g. Erfahrung) nach einer Nachrüstlösung suchen.
 
Alles ok @Nicknolte
Am Ende meines Start-Threads hatte ich ja auch nach einem Zubehör zur Marderabwehr gefragt ;)
Auch wenn es hier nicht hauptsächlich drum gehen sollte.

Ggf kann hier ja Bitte noch ein FL Besitzer sich mal die Mühe machen ein Foto vom Motorboden zu machen und hier einzustellen?
 
Hi, could you please take a picture showing where the 12 V marten protection and, if applicable, terminal 15 have been connected? To which fuse?
 
@Wolfi I plugged the K&K M4700B marten repellent into a free relay/fuse slot in the engine compartment fuse box using a standard flat connector. You can use a multimeter to test which contact has power. Ground it to the body point above the battery. The device requires permanent positive and has its own battery monitoring function (and by the way: I had the same model in my previous vehicle for 5 years and never had any problems even after longer periods of inactivity).
 
In our cars, the variants of Stop&Go installed are those that connect to ground and directly to the positive terminal of the battery, but they have their own fuse installed from the positive terminal to the device.
 
Thank you very much, the device is excellent. I will get one myself as well. With this device, you no longer need to connect terminal 15 in addition to the 12 V power supply.
Knowing that high-voltage cables in electric or e-hybrid vehicles must not be repaired and that replacing the wiring harness costs thousands of euros, such protection is actually indispensable.
 
K&K also have their own fuse in the cable.

With electric or hybrid vehicles, you can also consider a standalone device that does not need to be connected to the onboard network. You just have to remember to regularly replace the batteries. Martens do not hibernate; mating season is in summer. Therefore, it might be advisable to change the batteries in spring.
 

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

Back
Top