DIY Accessories

I see it the same way. Where is the Buy Now button?
 
Yes, I was wondering about that too. Two large, full bottles have quite a leverage effect on the relatively small clamp. On the outside, you could make the wall a bit longer (maybe in a triangular shape, pointing down like an arrowhead). On the inside, there’s also the possibility that the bottom for the compartment could be attached to the clamp, which would provide a stable support there as well. I wouldn't find a glue variant optimal, as the holder is only intended for temporary use during travel and shouldn't be left on permanently (at least that would be my preference).
 
In my opinion, the cup holders could be placed directly above the recess, and the indentation could be used entirely as a wedge. I think that with the shifted center of gravity, it would hold better during braking, acceleration, and in curves. I certainly do not need this recessed storage.
 
... I first need to check whether it holds purely through a clamp with possibly the support of double-sided tape
What if you 3D print the entire cutout? Then you could pack in crumbly snacks or something like that. 😁
 
Instead of just the floor, the entire storage compartment would also be more practical in my view, but it would certainly be more complicated to find the optimal fit.
 
I believe that the thing with cups inside looks extremely front-heavy and I would be afraid that it would break. Then you'd have sauce everywhere in the car...
 
You can only test by using closed bottles as test objects; I wouldn't use an open cup in the car anyway.
 
We have never eaten or drunk in the car. One can hold out for that long. Even when the kids were small: That's what you take breaks for on long trips. There is also no onboard toilet in the car.😉
 
The onboard toilet will then be the next project 🤣
 
  • Like
Reactions: ekm
@flash I think you weren't on the current page when you replied; the discussion about the shopping tokens hasn't been relevant for several pages now. ;)
 
Hello Milan,
I also stumbled upon this great discussion post today by chance.
Incredible what you have created. The garage door opener for the Leon is particularly well done. I might need something like that in February/March 2027 for our Cupra Raval Endurance. Is the circuit board compatible with all radio-controlled garage doors? The storage for the charging dock in the Leon is also practical. The coins at the very beginning looked top-notch as well. Can the parts be ordered from you via PM?
I take my virtual hat off to such creativity and commitment.
Regards,
SirOssy
 

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

Back
Top