Cupra-Klaus
Lebt hier ★
Hello everyone,
Today I gained some new insights regarding the Front Assist system. Perhaps this is also new for some of you: I drove home from work during heavy snowfall, and suddenly during the drive, the message "Front Assist not available. No sensor visibility" appeared, along with "Travel Assist not available". A clear assumption: the radar sensor located below the number plate had become blocked by snow. Upon arriving home, I checked: exactly as suspected—the entire front, including the sensor, was covered with a thick layer of snow about 2cm deep. So I cleaned the front, especially the sensor, then turned on the ignition or started the engine, expecting the error messages to disappear—but they were still present, even though the sensor was completely clean. I did a quick search online, and sure enough, I found several posts in the VW neighbor forums describing exactly the same situation. There it was mentioned that the system only performs a new check after the next drive starts, and the error only disappears then. And indeed, that’s what happened. I drove for another five minutes, and only then did the errors vanish
Today I gained some new insights regarding the Front Assist system. Perhaps this is also new for some of you: I drove home from work during heavy snowfall, and suddenly during the drive, the message "Front Assist not available. No sensor visibility" appeared, along with "Travel Assist not available". A clear assumption: the radar sensor located below the number plate had become blocked by snow. Upon arriving home, I checked: exactly as suspected—the entire front, including the sensor, was covered with a thick layer of snow about 2cm deep. So I cleaned the front, especially the sensor, then turned on the ignition or started the engine, expecting the error messages to disappear—but they were still present, even though the sensor was completely clean. I did a quick search online, and sure enough, I found several posts in the VW neighbor forums describing exactly the same situation. There it was mentioned that the system only performs a new check after the next drive starts, and the error only disappears then. And indeed, that’s what happened. I drove for another five minutes, and only then did the errors vanish
Last edited:
