Lack care, tips, experiences, etc.

Welcome! You have been invited by Bernhardt to join our community. Please click here to register.
Bei meinen örtlichen Händler geht das auch, aber wie soweit gesagt, nur Waschanlage...
KA ob die sowas aufm Hof stehen haben, oder der Wagen durch die benachbarte Tanke gerollt wird - wenn man sonst aber Händewasche in Betracht zieht, ist das leider keine Option..
 
Ob ich bei meinem 😀 durch die ("Massenabfertigungs-Billig-") Waschanlage möchte, ist auch ein ganz spezielled Thema. Meistens sehen die Autos danach schlimmer aus und man hat ggf. auch beim 😀 gerade keine freien Slots.

Eine externe Textilwaschanlage oder auch -straße wäre meine erste Wahl, auch wenn es ein paar Euro aus eigener Tasche kostet und man eben persönlich keine (oft verbotene) Handwäsche mag.
 
Don’t expect too much 😁

Even if you get a free interior cleaning like I did.

They just run the car once through the standard programme of their portal car wash. The brush usually doesn’t reach under the rear spoiler anyway, and inside they just briefly hold the vacuum over the floor mat, done.
I’ve stopped bothering with that and prefer to go to my well-known car wash with pre-cleaning and extra programmes. It costs a few euros, but it’s done properly, and I can also wipe down or touch up the critical areas with a towel straight away. Vacuuming is better done calmly at home anyway.
 
Mal ne Frage, bei mir an der Scheibe habe ich von innen langsam so eine Art hellen Film drauf, wenn ich dann mal wische, und je nach Sonneneinfall, sieht man wo ich hingekommen bin und wo nicht. Gibt es da irgendeinen Trick oder Empfehlung, ganz vermeiden lässt sich das ja wahrscheinlich nicht oder?
Bei unseren Mercedes ist das weniger, das sich da so ein Film bildet. Ich hoffe ich konnte es einigermaßen beschreiben....
 
Fettfilm durch Umwelteinflüsse. Die Lüftung/Klima bläst da halt alles Mögliche & Unmögliche drauf. Ist im Sommer fast schlimmer als im Winter. Da hilft eigentlich nur regelmäßig auch innen die Scheiben putzen. Gerade bei der Frontscheibe kommt man halt ganz bescheiden in die Ecken, außer man hat Chimpansenarme :ROFLMAO:
 
@JoergFB58 ja dachte ich schon, gibt wohl auch Tools, son Arm den man verlängern kann, irgendwelche Erfahrungen?
Ich habe leider nur Affenarme, lang und nichts dahinter :ROFLMAO: :ROFLMAO: :ROFLMAO:
 
@Ice-Mark versuch mal diese Empfehlungen für die Scheibenreinigung innen:

 
Falls ihr mal nicht so viel Zeit habt in der Waschbox und trotzdem eure Versiegelung wieder auffrischen möchtet, nutzt die ADBL Nassversiegelung! Aufspringen, abspülen,fertig. Für eine Nassversiegelung ein super Ergebnis und ihr bekommt dabei Lust auf ein Nutella-Brot 🙈 das Zeugs riecht so geil nach Hasselnuss-Creme.

Falls Kritik kommt.....Ich wachse mein Auto zweimal im Jahr und verwende zur Auffrischung nach der Handwäsche das ADBL Synthetic Spray Wax. Nassversiegelung wirklich nur wenn ich irgendwo im Urlaub bin und das Auto schnell mal abspritze.
 
exakt dasselbe ist mir auch negativ aufgefallen. Der Film ist spürbar dicker/stärker als bei bisherigen Wagen und zieht starke Schlieren. Mit einem speziellen Scheibenputztuch und Scheibenreiniger auch nur schwer zu entfernen. Es ist fast wie ein Fettfilm über der Herdplatte nach Wochenlangem kochen ohne zu reinigen.
Dazu sehe ich jetzt auch deutlich runde Stellen direkt hinter dem Innenspiegel. Es sieht so aus wie die Form eines Saugnapfes von einem Navi. (nur als Beispiel)
Diese Stelle kommt vor allem zum Vorschein wenn die Scheibe aufgrund Feuchtigkeit und Temperatur eh erst einmal stärker beschlägt und diese Stelle ausspart.
Trotz mehrfachen und intensivem Reinigen bekomme ich diese ausgesparte Stelle nicht weg.
 
Heute mal das neue Dr.Wack All in One Care&Protect (trocken) aufgetragen. Nutze sonst immer zum Versiegeln das Dr. Wack High End Spray Wax, ebenfalls trocken. Vom Auftragen und Auspolieren lässt sich das All in One Care&Protect meiner Meinung nach einfacher anwenden. Nicht dass das High End Spray Wax kompliziert wäre, aber es neigt schneller zu Schlieren wenn man zu langsam ist.
Von der "Farbauffrischung" erkenne ich keinen Unterschied zum High End Spray Wax, aber die Lackglätte ist beim All in One Care&Protect nicht so hoch wie beim High End Spray Wax. Die Hydrophobie ist bei beiden Produkten für mein Empfinden ziemlich gleich, vielleicht beim All in One Care&Protect ein ticken besser.
Mal schauen wie lange die Standzeit ist, ich wasche mein Auto so ca. alle 2-3 Wochen ausschließlich von Hand. Das High End Spray Wax war meistens nach 6-8 Wochen durch.
 

Attachments

  • 20260613_080627.jpg
    20260613_080627.jpg
    2.8 MB · Views: 25
  • 20260613_080640.jpg
    20260613_080640.jpg
    2.3 MB · Views: 25
@Tygulav ich muss sagen, dass ich echt zufrieden bin mit der Standzeit - nach 14 Tagen und etwas über 1.000km ist das Ganze noch sehr hydrophob...

Die fehlende Lackglätte ist etwas darauf zurückzuführen, dass das Produkt auch auf Plastik/Gummi angewendet werden kann.
Deshalb schmiert es auch weniger (wie Du selbst sagst: weniger Schlieren).

Mit dem Effekt kann ich persönlich sehr gut leben. Empfehle es aber nicht auf die Frontscheibe aufzutragen, da sorgt der Scheibenwischer aufgrund des mechanischen Abriebs über längere Zeit für Schlierenbildung.
 

Attachments

  • Dr. Wack All in One - 14 Tage, 1.106km (Lack) .jpg
    Dr. Wack All in One - 14 Tage, 1.106km (Lack) .jpg
    1.1 MB · Views: 13
  • Dr. Wack All in One - 14 Tage, 1.106km (Pano) .jpg
    Dr. Wack All in One - 14 Tage, 1.106km (Pano) .jpg
    1.5 MB · Views: 13
Here's another little update on the All in One Care&Protec from Dr. Wack:

I washed the car yesterday and everything still beaded off well - not as well as a month ago, but the effect was still very noticeable. Of course, I applied it again yesterday.

I first remove the foam residues with clear water and then go over it again with demineralized water. Then I spray Dr. Wack (on the wet paint) and dry the paint immediately with the microfiber cloth
 
Why first with normal water and then "shine rinse" to ensure everything is rinsed properly? I usually just do foam + shine rinse for a quick wash. That’s usually enough to quickly free the car from all insect residues after a long highway drive before it bakes in this weather. I actually have no residues from the foam and also almost no water spots if you roll a few kilometers and let the warm air dry the rest.
 
I'm doing it like @Angefixt, as the gloss rinse at my wash box is extremely short and would clearly consume more money. First, remove the entire product from the bucket wash with the clear rinse and then quickly bring down the water from the clear rinse with a gloss rinse.

So my steps are actually:

- Apply wheel cleaner (if necessary)
- Pre-cleaner (spray foam)
- High-pressure cleaning
- Bucket wash (2 buckets), at the end clean the wheels again with a wheel brush
- Clear rinse
- Gloss rinse
- Drying, possibly seal while wet
- If not sealed while wet, then seal while dry.

If it needs to be quick and the sealant is still good, then a quick clear rinse and a swift drive to dry is enough for me. 😅
 
  • Like
Reactions: ekm
@Tygulav

And after the quick drive to dry, the first insect carcasses are already on it again - a vicious circle. :D

Regarding the matte paint of my Leon, I have to say that it is easier to care for than I initially thought. My vehicles only receive loving hand washes under the home carport anyway. Only the drying or wiping off feels strange with the matte paint, as the paint is really rough.
 
@ekm spray some demineralized water on the remaining foam...
You just can't effectively get it off because the foam can't dissolve.

That's why it's always better to rinse off all the foam/pre-cleaner with "normal" water, and then you actually only need to mist the vehicle with the gloss rinse program - that's usually more than enough.
 
  • Like
Reactions: ekm
Okay, so it's mainly about rinsing everything off completely. It could have been that there was another reason, which is why I asked my question.

I always managed to get the foam off with distilled water by basically pushing it down from top to bottom. As I said, I only use it for quick cleaning. At Toral and Aral, you can remove about 95% of the dirt in the summer. For on-the-go in 2 minutes and just as many euros, it's definitely sufficient.

For home hand washing, I will try Dr. Wrack; I have the means to get everything 100% clean, but since only relatively hard water is available there, it causes the spotting problem. If you have to wipe dry anyway, you can combine it (just like you wrote)👍.
 

After vehicle acquisition​


  • New vehicle initially thoroughly washed
  • Paint kneaded
  • Paint fully polished
  • NeoWax No.5 Graphene – paint sealant
  • subsequently NeoWax No.2 Wax
  • Wheels with Gyeon Q² Rim EVO ceramically sealed
  • deep black areas (pillar trims, side skirts, roof edge spoiler) also ceramically sealed

Regular washing​

Vorwäsche

  • Active 2.0 high-pressure cleaner
  • Schaumlanze
  • Labocosmetica 3-phase system
  • Primus 2.0
  • Purifica
  • Semper
  • or Sonax Actifoam Energy
  • depending on the degree of soiling and type of dirt
  • all four products can be used both as snow foam and as a wash additive in water
  • Application according to manufacturer specifications
Handwäsche

  • 2-Eimer-Methode
  • Petzold's wash mitt and ChemicalWorkz wash mitt
  • Labocosmetica Primus 2.0 / Purifica / Semper depending on need also as shampoo or wash additive
Felgen

  • ChemicalWorkz wheel mitt and ChemicalWorkz microfiber wheel brush
  • ADBL Vampire Elixir
Trocknung
  • Black Hole drying towels
  • small magnetic drying towels for critical areas (e.g., exterior mirrors, roof area, etc.)
  • Work Stuff Gentleman Basic microfiber towels for door sills, seams, etc.
 
Last edited:

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

Back
Top