Switch from hybrid mode to electric operation

Welcome! You have been invited by Gand-Alf to join our community. Please click here to register.

Jürgen

Ist öfter hier
Hello everyone,

I have now been driving my new and first hybrid for over 3 months. So far, I have covered 4,000 km and was initially quite satisfied, but in the last 6 weeks I have already had to visit the workshop twice.
Among other things, I have recently often had the problem that I cannot switch from hybrid mode to pure electric mode.
The system then shows me “The electric mode is currently not available”……possible reasons are: A. The speed is too high. B. The battery charge is too low.
However, both statements are not correct, as the car was stationary each time and the battery charge was always between 50 and 90%.

The operating Manual* says the following about this:
To activate the electric driving mode, all of the following conditions must be met:
- The state of charge of the high-voltage battery is sufficient
- The driving speed is below 130 km/h
- The temperature of the high-voltage battery is above -10°C.
Incidentally, the temperature ranges at the time of the message were between +5 and 10°C each time.
In this respect, the workshop manager’s statement is unclear to me; this is a system-related message that does not indicate a fault.

Does anyone perhaps have the same problem and can explain it to me in more detail?
 

Attachments

  • image6.jpeg
    image6.jpeg
    1.6 MB · Views: 37
hm, looks like Cologne xD
Your photo is unfortunately a bit blurry, in the instrument cluster to the left of the battery you seem to have a symbol, what does it show you here?
What does the car do when you are stopped at the traffic light? Does the engine stay on the whole time here as well?
 
@Ice-Mark You mean in the centre of the left tube (tachometer)?
94% charge level. Otherwise, I don't see any battery.
It says on the photo @Jürgen You were still wondering yesterday in another thread ( ... ) to some extent why the hybrid does not switch to or stay in electric mode.

Besides the conditions that @Jürgen listed (see BA Leon p. 232), which are obviously met (therefore I do not understand the statement of the Frdl. either), it says on the aforementioned p. 232:

The combustion engine of the vehicle will preferably not be used.

what does "preferably" mean? Charge status 100%, for example?
 
Did you possibly have the "Hold charge level" option activated?

Otherwise, especially at the traffic light, just turn off the ignition and restart, then it should immediately be in E-mode.
 
Morning all,
yeah, the photo is a bit blurry, but unfortunately I don’t know which symbol you mean either. @Ice-Mark you mean?
In fact, the combustion engine stays running when stationary, which can also be seen on the tachometer... which I also cannot understand.

Regarding the statement by @ekm "Maintain charge level" was not active just now, and I had actually already noticed that after a restart I initially operate in electric mode again, which cannot be the solution.
Maybe I'm being a bit picky here, but if all conditions are met and the switch from hybrid to electric cannot be executed, then in my understanding that is a system error, isn't it? 🙁
 
@Jürgen Yes, I meant the battery, it looks to me a bit like there is something small next to the battery that is directly lit... but all good.
@Gand-Alf If you see a white area on the rev counter, you can tell that the engine is running; otherwise, it stays dark on the plug-in models, and you then have an additional blue bar for the power of the electric motor, where you can also clearly see from which point the combustion engine kicks in, and a green bar where you can see the regenerative braking ☺️
 
hatte den Fall bisher auch noch nie, das Auto will eher lieber nur elektrisch fahren und lässt sich nicht direkt einstellen nur über Verbrenner zu fahren...
 
@Gand-Alf: Start-Stop in dem Sinne, also wie in einem reinen Verbrenner gibt es bei diesem Fahrzeug doch nicht.
Eigentlich sollte hier der Verbrenner im Stand immer abschalten (zumindest bei ausreichender BatterieLeistung), was er in diesem Fall ja nicht tut.

@Ice-Mark : einen Wechsel in den reinen Verbrenner geht natürlich nicht und hatte ich auch nicht gepostet, sondern der Wechsel aus dem Hybridmodus in den Elektrobetrieb ist das Problem.
 
deswegen kann ich dir nur von mir sagen, bisher noch nie das Problem gehabt... auch wenn es dir nicht weiterhilft, normal scheint es aber nicht zu sein....
 
Wie schnell nach dem Wechsel auf Hybrid Modus versuchst du wieder in den E Modus zu gehen? Bei meinem VFL Leon ist der E Modus auch direkt deaktiviert nach dem Anspringen des Motors. (für einen gewissen Zeitraum) erst nach einer geraumen Zeit kann ich wieder in den E Modus wechseln. Ich denke das hat auf jeden Fall damit zutun, dass der Benzin Motor kurz mal mindestens den Kaltstart hinter sich hat, und man so nicht den Motor nur für 5 Sekunden laufen lässt.
So ist es im VFL > ob es im FL auch so ist kann ich nicht sagen, wäre aber eine Idee
 

* = Advertisement
Links marked with an asterisk (*) are affiliate links. If you click on one of these links and make a purchase, we receive a commission from the respective online shop or provider. This does not affect the price you pay.

cupra.forum · Alle Rechte vorbehalten · Dies ist kein Forum der Seat Cupra S.A.U.
Back
Top