Burns
War schon mal da
Hello dear Terramar colleagues,
I have noticed after repeated searches on the web: there is still no reasonable solution to place hooks on the back of the front seats. My previous company car was a Seat Ateca, where there were the well-known headrests anchored in the seat with two chrome metal rods. There, I had a standard hook solution attached and could easily hang my shopping bag, etc. No shopping spread across the back seat, no unsightly mess.
In the Terramar, everything is different, as we know; the seats have more of a shell design - without the usual headrest attachment. So, a commercially available solution unfortunately falls flat. There is only this small triangular recess at about neck height. So far, I have only found a tablet holder on the web that takes advantage of this small recess. However, it looks like a 3D-printed part and according to the description, this holder is only intended for use while stationary - very funny
Assuming I at least use the anchoring of the tablet holder and attach a hook to it... and now hang my shopping bag (which can certainly weigh 5kg) on it, I will probably regret it in the next second
.. and for that, nearly 40 euros is too expensive for me.
My question to the community: has anyone of you had the same thought as I have and found or created an adequate solution that could be adopted? This topic should also be of interest for the Tavascan.
I have noticed after repeated searches on the web: there is still no reasonable solution to place hooks on the back of the front seats. My previous company car was a Seat Ateca, where there were the well-known headrests anchored in the seat with two chrome metal rods. There, I had a standard hook solution attached and could easily hang my shopping bag, etc. No shopping spread across the back seat, no unsightly mess.
In the Terramar, everything is different, as we know; the seats have more of a shell design - without the usual headrest attachment. So, a commercially available solution unfortunately falls flat. There is only this small triangular recess at about neck height. So far, I have only found a tablet holder on the web that takes advantage of this small recess. However, it looks like a 3D-printed part and according to the description, this holder is only intended for use while stationary - very funny
My question to the community: has anyone of you had the same thought as I have and found or created an adequate solution that could be adopted? This topic should also be of interest for the Tavascan.


